2.7.2
Displaying the work offset "overview"
The active offsets or system offsets are displayed for all set-up axes in the "Work Offset -
Overview" window.
In addition to the offset (course and fine), the rotation, scaling and mirroring defined using
this are also displayed.
This window is generally used only for monitoring.
Display of active work offsets
Work offsets
DRF
Rotary table reference
Basic reference
External WO frame
Total base WO
G500
Tool reference
Workpiece reference
Programmed WO
Cycle reference
Total WO
Procedure
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Displays the handwheel axis offset.
Displays the additional work offsets programmed with $
P_PARTFRAME.
Displays the additional work offsets programmed with $P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
Displays the additional work offsets programmed with $P_EXTFRAME.
Displays all effective basis offsets.
Displays the work offsets activated with G54 - G599.
Under certain circumstances, you can change the data using "Set
WO", i.e. you can correct a zero point that has been set.
Displays the additional work offsets programmed with
$P_TOOLFRAME.
Displays the additional work offsets programmed with $P_WPFRAME.
Displays the additional work offsets programmed with $P_PFRAME.
Displays the additional work offsets programmed with
$P_CYCFRAME.
Displays the active work offset, resulting from the total of all work
offsets.
1.
Select the "Parameter" operating area.
2
Press the "Work offset" and "Overview" softkeys.
The "Work Offsets - Overview" window opens.
Setting up the machine
2.7 Work offsets
91