Siemens SINUMERIK 828D Operating Manual page 77

2 holes
3 holes
4 holes
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
• Enter the approximate diameter into "Øhole".
• In "Angle offs.", select entry "Coord. rotation".
- OR -
In "Angle offs.", select the "Rotary axis A, B, C" entry.
• Enter the setpoint angle.
• Specify the position setpoints (X1/Y1) for the center point of the
first hole.
X1 and Y1 are only active, if the "Coor. rotation" entry is selected.
- OR -
• Enter the approximate diameter into "Øhole".
• In "Angle offs." select entry "No".
- OR -
In "Angle offs." select entry "Yes" if you want alignment to be
performed with coordinate rotation.
• Enter the setpoint angle.
The angle entered here refers to the 1st axis of the working plane
(X/Y plane). This input field only appears if you specified "Yes" for
"Angle offs."
• Specify setpoint positions X0 and Y0.
These determine the center point of the circle on which the center
points of the three holes are to lie.
- OR -
• Enter the approximate diameter into "Øhole".
• In "Angle offs." select entry "No".
- OR -
• In "Angle offs." select entry "Yes" if you want alignment to be
performed with coordinate rotation.
• Enter the setpoint angle.
The angle entered here refers to the 1st axis of the working plane
(X/Y plane). This input field only appears if you specified "Yes" for
"Angle offs."
• Specify setpoint positions X0 and Y0.
These determine the point of intersection of the lines connecting
the hole center points.
7. Press the <CYCLE START> key.
The tool automatically probes 4 points of the inner sides of the pocket
or hole in succession.
After the measurement has been successfully completed, the "P1
stored" softkey becomes active.
8. Then move the tool approximately to the center of the second, third,
and fourth hole and press the <CYCLE START> key.
After measuring points P2, P3, and P4 have been successfully
measured, the "P2 stored", "P3 stored", and "P4 stored" softkeys
become active.
Setting up the machine
2.6 Measuring the workpiece zero
77