Siemens SINUMERIK 828D Operating Manual page 60
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Setting up the machine
2.5 Measuring the tool
Requirements
● No function-related settings are necessary after the measuring cycles have been
● Before the actual measurement, enter approximate values for length and radius or
● Calibrate the probe first.
Lateral/longitudinal offset
You can consider a lateral or longitudinal offset V when measuring. If the maximum length of
the tool is not at the outer edge of the tool or the maximum width is not at the bottom edge of
the tool, you can store this difference in the offset.
If measuring shows that the length of the tool diameter is greater than the probe diameter,
measurement is automatically performed with a turning spindle rotating in the opposite
direction. The tool is then not moved over the probe center-to-center, but with the outside
edge of the tool above the center of the probe.
Procedure
60
installed.
diameter of the tool in the tool list.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1.
Insert the tool that you want to measure.
2.
Select "JOG" mode in the "Machine" operating area.
3.
Press the "Meas. tool" softkey.
4.
Press the "Length auto" softkey if you want to measure the length of
the tool.
- OR -
Press the "Radius auto" or "Diameter auto" softkey if you wish to
measure the radius or diameter of the tool.
5.
Select the cutting edge number D and the number of the replacement
tool ST.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling
Advertisement
Table of Contents
