Displaying The Current Program Block; Current Block Display - Siemens SINUMERIK 828D Operating Manual
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Machining the workpiece
4.4 Displaying the current program block
See also
Setting for automatic mode (Page 153)
4.4
Displaying the current program block
4.4.1
Current block display
The window of the current block display shows you the program blocks currently being
executed.
Display of current program
The following information is displayed in the running program:
● The workpiece name or program name is entered in the title row.
● The program block which is just being processed appears colored.
124
3.
Press the <CYCLE START> key.
Depending on the execution variant, the first block will be executed.
Then the machining stops.
In the channel status line, the text "Stop: Block in single block ended"
appears.
4.
Press the <CYCLE START> key.
Depending on the mode, the program will continue executing until the
next stop.
5.
Press the <SINGLE BLOCK> key again, if the machining is not
supposed to run block-by-block.
The key is deselected again.
If you now press the <CYCLE START> key again, the program is
executed to the end without interruption.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling
Advertisement
Table of Contents
