Line Position Pattern (Holes1) - Siemens SINUMERIK 828D Operating Manual

Programming technological functions (cycles)
8.1 Drilling
Parameter Description
LAB - (only for G Repeat jump label for position
code)
PL - (only for G Machining plane
code)
Selection - Coordinate system
(only for ShopMill)
Rectangular
•
Polar
•
- (only for Polar coordinates of the 1st position for "polar" selection
ShopMill)
L0 Length (abs.)
C0 Angle (abs.)
X0 X coordinate for 1st position (abs.)
Y0 Y coordinate for 1st position (abs.)
- (only for Polar coordinates of additional positions, for "polar" selection
ShopMill)
L1 ... L7 Length (abs.)
C1 ... C7 Angle (abs.)
X1 ... X7 X coordinate for further positions (abs. or inc.)
Y1 ... Y7 Y coordinate for further positions (abs. or inc.)
8.1.11

Line position pattern (HOLES1)

Function
In the "position pattern" cycle you can program the following patterns in the selection option
in the "Position pattern" parameter.
● Line
● Grid
● Frame
234
In the "Line" selection option you can program any number of positions at equal distances
along a line.
You can use the "Grid" selection option to program any number of positions spaced at an
equal distance along one or several parallel lines.
If you want to program a rhombus-shaped grid, enter angle αX or αY.
You can use the "Frame" selection option to program any number of positions spaced at
an equal distance on a frame. The spacing may be different on both axes.
If you want to program a rhombus-shaped frame, enter angle αX or αY.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Unit
mm
Degrees
mm
mm
mm
Degrees
mm
mm
HMI sl Milling