5.7.2
Simulating the program block by block
You can control the program execution during simulation, i.e. execute a program block by
block, as when executing a program.
Procedure
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
- OR -
Press the "Override 100%" softkey to set the feedrate to the maximum
value.
- OR -
4.
Press the "<<" softkey to return to the main screen and perform the
simulation with changed feedrate.
1.
Simulation is started.
2.
Press the "Program control" and "Single block" softkeys.
3.
Press the "<<" and "Start SBL" softkeys.
The pending block of the program is simulated and then stops.
4.
Press "Start SBL" as many times as you want to simulate a single
program block.
5.
Press the "Program control" and the "Single block" softkeys to exist the
single block mode.
Simulating machining
5.7 Program control during the simulation
163