Basic Functions - Siemens SINUMERIK 828D Operating Manual

PCU321

15.2 Basic Functions

15.2 Basic Functions
Note
After the control powers up, the "Diagnostics" operating area opens, defined by an ini file.
Contrary to the HMI sl standard software, the "Machine", "Parameter", "Program" and
"Program Manager" operating areas arenot displayed.
The basic functions are grouped in the following operating areas in the control - as opposed
to the HMI sl standard software:
● Diagnostics
● Commissioning
Diagnostics operating area
The alarm list, messages, alarm reports, the variable overview (PLC) and the version are
displayed in the Diagnostics operating area.
● An alarm is generated if erroneous states are detected when operating the PCU 321. It
● If the PLC outputs messages, these are displayed in a message overview together with
● Alarms and messages that have occurred are displayed in the sequence in which they
● In the variable view (PLC), status control values can be viewed and changed.
● When pressing the "Version" softkey, the window for the version data opens. All system
Note
Contrary to the HMI sl standard software, no information is output about PROFIBUS
diagnostics, axis diagnostics, Safety Integrated diagnostics and on the system utilization
level.
430
Alarm list, messages, alarm report, variable view and version
See Commissioning Manual.
consists of an alarm number and an error text describing the cause of the error. These
alarms can be either deleted or acknowledged.
the date, message number and message text.
were received.
software components are shown here with their corresponding version data.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling