Figure 85: Xrc Communication Wiring - ABB XSeriesG4 User Manual

Transceiver check
Step-by-step instructions
If available, use a wattmeter to check the transceiver output power. Refer to the manufacturer's documentation for
measuring instructions.
If available, use two hand-held transceivers, and verify the communication path between master and remote sites. Voice-
activated interface can be used, if available.
Verify that the transceiver is set to the correct frequency. Refer to the manufacturer's documentation for checking
frequency instructions.
If a directional antenna is used, verify the orientation to the antenna to the master site.
NOTE: If a communication problem still exists and the unit has passed the transceiver check test, contact
Totalflow Technical Support for additional help.
G4
Figure 85: XRC Communication Wiring
XSeriesG4 Remote Controller User's manual 2103334 Rev. AB | 97
5 Troubleshooting