Figure 46: Network Id Setup - ABB XSeriesG4 User Manual

IMPORTANT NOTE: The local connection can use private IP addressing for the point-to-point communication
between the XRC and the PC or laptop. The XRC has a default private network IP address already assigned from
the factory (169.254.0.11). The PC or laptop must be configured to obtain its own IP address automatically. When
setup for automatic addressing, when the laptop connects to the enabled XRC Ethernet port, it automatically
configures a compatible IP address.
For additional details on the IP addressing setup for the PC or laptop click Help from the Network screen.
To enable and setup the Ethernet port:
Establish a local connection to the Entry screen as described in section 3.3, Establishing initial local communication.
Connect the XRC Ethernet port to the PC or laptop Ethernet port with a crossover Ethernet cable
Select Communications> Network tab from the navigation tree. The Network screen displays with options to configure
the Ethernet port or Network Adaptor (Figure 46).
In the Network ID value field type the Network ID.
Set Network Adaptor to Enable.
Click Send.
Click OK to confirm changes.
On the navigation tree, select Communications > Totalflow/TCP>Setup tab to view or change additional port
parameters (Figure 47). The default protocol enabled on the port is Totalflow/TCP.

Figure 46: Network ID setup

XSeriesG4 Remote Controller User's manual 2103334 Rev. AB | 47
3 XRCG4 startup