Figure 54: Pccu32 Security Code Setup - ABB XSeriesG4 User Manual

Click Send.
Turning the security switch (S1) on will activate the security codes. The level 1 code (example above: '1234') will allow data and
configuration values to be read, but not altered. The level 2 code (example above: '5678') will allow full access to read and to
write.
These security codes must be entered into PCCU32 and WinCCU32 to provide appropriate access to the meters. However,
WinCCU32 will always need the proper security code, regardless of the position of the security switch (S1). Turning the security
switch off does not allow unprotected access by a WinCCU32 operator.
NOTES: If the security level is breached, the meter will give no indication. Any data the operator attempted to
change will simply remain unchanged.
There are additional fields stored in WinCCU for uniquely identifying the meter, including fields for entering the
lease holder, producer, operator and buyer. These fields reside on the host computer in the ID manager, not in the
G4
XRC .
PCCU32 security
Accessing the meter with PCCU32, when the security switch (S1) is activated, requires the appropriate security code be
entered.
1. To enter the security code, go to the System Setup menu in PCCU32. In the example (Figure 54), the operator has
read-only access to the meter.
A security code level 1 (below example) of '1234' will provide read only access to the meter. A security code of '5678' would give
the operator full read and write access to the meter.
NOTE: If the security level is breached, the meter will give no indication. Any data the operator attempted to change
will simply remain unchanged.

Figure 54: PCCU32 Security Code setup

58