Setting Up The Xrc - ABB XSeriesG4 User Manual

Start PCCU.
Click Setup from the toolbar. The Setup screen for communication displays (Figure 52).
Under Communications, select TCP/IP as the PCCU connect method.
In the Network ID field type configure one of the following:
a.
The address of the XRC and the TCP port for the connection (in the following format: xxx.xxx.xxx.xxx/TCP port
number).
b.
The IP address of the onsite router/cell modem and the TCP port for the connection (in the following format:
xxx.xxx.xxx.xxx/TCP port number.
Click Close to exit setup and return to the PCCU main screen
Click Entry from the toolbar. When the Entry screen displays, the Ethernet connection over the network is successful.

Setting up the XRC

As previously instructed, once physically connected to the XRC
At this time, the software will actually read the device default values programmed at the factory. These preset values are based
on the type of product ordered and are programmed for the most widely used configuration.
Depending on the programming device used, the following are the minimum required entries. Specific information required to
complete each step (depending on the equipment choice) is discussed in the PCCU32 help files.
Figure 52: Connection setup over Ethernet using non-default TCP port
G4
G4
, the user instructs the host software to connect to the device.
XSeriesG4 Remote Controller User's manual 2103334 Rev. AB | 55
3 XRCG4 startup