Frame Size R9; Auxiliary Cooling Fan Replacement - ABB ACH580 Series Installation, Operation And Maintenance Manual

84

Frame Size R9

To replace the fans:
1. Remove power from drive.
2. Remove the 2 screws attaching the fan mounting plate.
3. Turn the mounting plate downwards.
4. Disconnect the fan cables
5. Remove the mounting plate.
6. Remove the fans by removing the 2 mounting screws.
7. Install the fan in reverse order.
8. Restore power.
2

Auxiliary cooling fan replacement

Auxiliary cooling fans are not speed-controlled and run all the time that the control
board is powered. Replacement fans are available from ABB. Do not use other than
ABB specified spare parts.
IP21/UL (NEMA) Type 1 and IP55/UL (NEMA) Type 12 Frame Sizes R5...R9
To replace the fan:
1. Remove power from drive.
2. Remove the front cover.
3. Disconnect the fan cable.
4. Release the retaining clips.
5. Lift the fan off.
6. Install the fan in reverse order.
Note: Make sure that the arrow on the fan points up.
7. Restore power.
ACH580-01 Installation
ACH580 Installation, Operation and Maintenance Manual
4
2
3
6
5
6
4