Softkeys - Siemens SINUMERIK 840C Installation Instructions Manual

9 Drive Servo Start-Up Application (as from SW 3)
9.1.1 Selection of/menu trees drive servo start-up application
D Menu tree: Spindle start-up function
1)
Measure- Meas.
ment
paras.
Measure- Meas.
ment paras.
Measure- Meas.
ment paras.
Measure- Signal-
ment paras.
9.1.2

Softkeys

Start
Stop
1) as from SW 4
9–6
Start-up
fct. spindle
1)
Current Speed
contr. loop
contr. loop
Contr.para Display
drive
Contr.para Display
drive
Contr.para Contr.para Display
drive NC
Contr.para Contr.para
drive NC
This softkey enables the measurement or the DAC output. In order to start a
measurement with traversing operation, the traverse enabling commands set by
means of toggle field from the PLC/NC must be available. This operator action is
acknowledged by an appropriate message.
The measurement or the DAC output is enabled by selecting the Start softkey,
but can be disabled again with the Stop softkey. The function is aborted if the
Recall hardkey is pressed without a preceding NC start command.
This softkey aborts the measurement, DAC output or traversing operation
(function generator, QEC learning process) which is in progress.
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
Position Function
contr. loop generator
File
functions
File
functions
File
functions
File
functions
SINUMERIK 840C (IA)
09.95