Siemens SINUMERIK 840C Installation Instructions Manual page 364

01.99
1708*-
Time constant parallel model 2nd - 8th parameter set
1732*
Default value
6 000
These MD have the same meaning as MD 1432*, see also "Functional Descriptions:
Parameter set switchover".These machine data are only active with gearbox interpolation.
1736*-
Alarm limit velocity 1st - 8th parameter set
1764*
Default value
11 000
Meaning: Limitation of max. velocity for following axis. These machine data are only active with
gearbox interpolation.
Note:
For parameter grouping see under "Functional Descriptions: Parameter set switchover".
1768*-
Alarm limit acceleration 1st - 8th parameter set
1796*
Default value
55
Meaning: Limitation of max. acceleration for following axis. These machine data are only active
with gearbox interpolation.
Note:
For parameter grouping see under "Functional descriptions: Parameter set switchover".
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
(as from SW 4)
Lower input limit Upper input limit
0
(as from SW 4)
Lower input limit Upper input limit
1 99 999 999
(as from SW 4)
Lower input limit Upper input limit
0
6FC5197- AA50
6.7 Axis-specific MD 2 (axial data 2)
Units
16 000 0.01 ms
Units
10 000 units/s
Units
16 000 10 000 units/s
Active on
RESET
Active on
NC Stop
2
Active on
NC Stop
2
6–179