Siemens SINUMERIK 840C Installation Instructions Manual page 387

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.9 MDs for parameter set switchover
3032*-
Number of teeth motor
3060*
Default value Lower input limit
1
3064*-
Number of teeth spindle
3092*
Default value Lower input limit
1
This machine data is used to define the speed ratio of a gear box for all parameter sets, see
functional description of ""Ratio" parameter group".
3096*-
Zero mark correction +
3124*
Default value Lower input limit
0
16 000 (as from SW 4.4)
3128*-
Zero mark correction -
3156*
Default value Lower input limit
0
16 000 (as from SW 4.4)
These MDs are used to correct gear-stage-related offsets between the zero mark and
reference position, see functional description of ""Ratio" parameter group".
3160*-
Backlash comp. 1st measuring system
3184*
Default value
0
For axes only:
To compensate for the backlash in different gear stages.
3188*-
Motor control equilibration 2nd - 8th par. set
3212*
Default value Lower input limit
0
-700 (as from SW 4.4)
These MD have the same meaning as MD 1292*, see also "Functional Descriptions:
Parameter set switchover".
_______
1) As from SW 4.4
2) As from SW 4
6–202
2)
1st par. set to 8th par. set
Upper input limit
1
99 999 999 (as from SW 4.4)
2)
1st par. set to 8th par. set
Upper input limit
1
99 999 999 (as from SW 4.4)
2)
1st par. set to 8th par. set
- 999 999
16 000 (as from SW 4.4)
2)
1st par. set to 8th par. set
- 999 999
16 000 (as from SW 4.4)
8th par. set
Lower input limit
- 16 000
as from SW 4
Upper input limit
-70
-700 (as from SW 4.4)
©
Siemens AG 1992 All Rights Reserved
999 999
999 999
Upper input limit
999 999
Upper input limit
999 999
2)
2nd par. set to
Upper input limit
16 000 units (MS)
70 0.1 % of the power
section current
SINUMERIK 840C (IA)
09.95
Active on
Power On
Units
–
Active on
Power On
Units
–
Active on
NC Stop
Units
units (MS)
Active on
NC Stop
Units
units (MS)
Active on
NC Stop
Units
Active on
NC Stop
Units
6FC5197- AA50