Siemens SINUMERIK 840C Installation Instructions Manual page 347

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.7 Axis-specific MD 2 (axial data 2)
1184*-
Feedforward control factor 4th - 7th parameter set
1196*
Default value
0
This MD has the same meaning as MD 312*, see also functional description of parameter set
switchover.
1200*
Default value
0
With this MD, it is possible to set a time where the contour deviation may exceed that of MD
*
332 without an alarm message "Contour monitoring" being output.
f: Pulse multiplication EXE/611D/HMS 2nd measuring
1204*
Default value
1
Active: After POWER ON
The matching of the internal computing precision and the precision of the second measuring
system is carried out in the same way as the settings for the first measuring system
(MD 364*/368*/1116*).
_______
1) As from SW 2
2) As from SW 3
3) As from SW 4
6–162
Lower input limit Upper input limit
+0
Delay for contour monitoring
Lower input limit Upper input limit
0
1)
system
Lower input limit Upper input limit
1
©
Siemens AG 1992 All Rights Reserved
3)
Units
1 000 0.1%
Units
16 000 ms
Units
1)
128
2)
512
6FC5197- AA50
SINUMERIK 840C (IA)
04.96
Active on
NC Stop
Active in all
channels of
mode group
in STOP
Active on
Power On
–