Standard Installation And Start-Up As Flowchart (As From Sw 3) - Siemens SINUMERIK 840C Installation Instructions Manual

2 General Reset and Standard Start-Up

2.2 Standard installation and start-up as flowchart (as from SW 3)

2.2 Standard installation and start-up as flowchart (as from SW 3)
Default values can be used for data in general reset mode during initial installation
or after a loss of data caused by, for example, removal of a module, hardware
defect of a module or empty back-up battery in the case of power failure.
Start-up switch on CSB
in position "Start-up"
(1)
Switch on
General reset mode
refer to General Reset
Section
Softkey time/date
Set time and date
Load MD in MDD
Configure memory
(as from SW 4)
Start-up
control
END
2-2
START
MMC-CPU
supplied with system
Yes
software
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
No
Connect
Valitek streamer
Switch on
Booting performed in
Backup menu
Load system software
from magnetic tape,
see Backup Section 4
Switch off
SINUMERIK 840C (IA)
09.95
08.96