Siemens SINUMERIK 840C Installation Instructions Manual page 590

10.94
11009
Default value
–
This machine data specifies the capacity utilization of the digital drive as a percentage
(0 ... 7FFF H ˆ = 0 ... 100%).
11010
Default value
–
This machine data specifies the torque setpoint of the digital drive as a percentage
(-32768 ... 32767 ˆ = -200% ... 200%). The torque corresponding to 100 % (internal notation
4000 H) is stored in machine data "Scaling torque setpoint interface" (MD 1725).
11011
Default value
–
This machine data specifies the active power of the digital drive.
11012
Default value
–
This machine data specifies the current actual value of the digital drive as a percentage
(-32768 ... 32767 ˆ = -200% ... 200%). The limit current corresponding to 100 % (internal
notation 4000 H) is stored in the machine data "Transistor limit current power section" (MD
1107).
11013
Default value
–
This machine data specifies the current actual value of the digital drive. The actual speed
value corresponding to 100 % (internal notation 4000 H) is stored in the machine data "Speed
for max. motor operational speed" (MD 1401).
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
7.4.3 Diagnosis/service MD (data description - as from SW 3)
Capacity utilization (as from SW 4)
Lower output limit Upper output limit
0000
Torque setpoint (as from SW 4)
Lower output limit Upper output limit
-32 768
Active power (as from SW 4)
Lower output limit Upper output limit
-327.68
Current actual value (as from SW 4)
Lower output limit Upper output limit
-32 768
Speed actual value (as from SW 4)
Lower output limit Upper output limit
-200
6FC5197- AA50
7 Drive Machine Data (SIMODRIVE Drive MD)
Units
7FFF Hex
Units
32 767
Units
327.67 kW
Units
32 767
Units
200
Active
at once
Active
at once
–
Active
at once
Active
at once
–
Active
at once
%
7–175