Siemens SINUMERIK 840C Installation Instructions Manual page 100

09.95
The configured texts are activated on Power on.
Fig. 4.16
4.4.3.3 Configuration file BEDCONF in directory/Operation/DIAGNOS
If changes are made in the system menus NC service, PLC service and NC info,
line
d 2 5 51 127,0 105,0 102,0 // NC service PLC service NC info
must be replaced by
d 2 5 51 127,4 105,4 102,4 // NC service PLC service NC info
in this file.
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
35 L
F
36 a 4 5 232 \
37 '– ' 'Slide1' 'Slide2' 'PORTAL' 'Loader' L
38 d 1 1 0 L
F
39 L
F
4 MMC Area Diagnosis
4.4.3 BEDCONF configuration file
// Values for
F
4–37