3) Go back to step (2), print out a test pattern again, and check the D pattern. Repeat this
procedure until the number of block that shows the most indistinct horizontal lines
comes to be 2.
2.5
Adjustment of vertical print lines/software correction for inclination/
corrugation/ruled lines (Maintenance mode 65)
Refer to
Chapter 5, Section
2.6
Update paper feeding correction values (Maintenance mode 58)
Refer to
Chapter 5, Section
2.7
Adjust margins in borderless printing (Maintenance mode 66)
Refer to
Chapter 5, Section
2.8
Write head calibration data (Maintenance mode 02)
Refer to
Chapter 5, Section
2.9
Check scanning and printing
Refer to
Section 1.16
1.3.23.
1.3.19.
1.3.24.
1.3.2.
in this chapter.
4-18
A
B
(5_002_1_E)
Confidential