NEC Univerge SV8100 VM8000 InMail System Manual page 188

Issue 1.0
3.
4.
5.
2 - 160
14-02-10 Analog Trunk Data Setup - Caller ID
Enable (1) a trunk's ability to receive Caller ID data.
By default, a trunk's ability to receive Caller ID data is disabled (0).

14-01-22 Basic Trunk Data Setup - Caller ID to Voice Mail
Enter 1 (Yes) to enable this option.
By default, this option is disabled.

20-09-02 Class of Service Options (Incoming Call Service) - Caller ID Display
Enter 1 (Yes) to enable the Caller ID display at an extension.
By default, this option is disabled.

20-06-01 Class of Service for Extensions
Assign Class of Service to extensions.
By default, extension 101 has Class of Service 15. All other extensions have Class

of Service 1.
Set up Trunk Group Routing.
Make Call callouts use Trunk Group Routing (dial 9) when selecting outbound routes.
14-05-01 Trunk Groups
Assign trunks to trunk groups (1~8).
By default, all trunks are in group 1.

14-06-01 Trunk Group Routing
Set up Trunk Group Routing. There are 8 routing tables, with 4 routes in
each table.
By default, the first route in routing table 1 is trunk group 1. No other entries are

defined. This makes trunk group 1 the dial 9 route by default.
Refer to Trunk Group Routing in the VM8000 InMail Programming Manual
for more.
Enable Loop Supervision for the trunks on which you are going to allow remote
logons to use Make Call.
14-01-13 Basic Trunk Data Setup - Loop Supervision
Enter 1 to enable Loop Supervision for each trunk to be used for External
Transfer.
By default, this option is enabled for all trunks.

If you are going to allow remote logos to use Make Call, enable Trunk-to-Trunk
Transfer for all VM8000 InMail extensions.
20-11-14 Class of Service Options (Hold/Transfer Service) - Trunk-to-Trunk
Transfer Restriction
For each VM8000 InMail extension to be used for External Transfer, enter 0
to enable Trunk-to-Trunk Transfer Restriction. (Entering 1 disables
Trunk-to-Trunk Transfer Restriction).
VM8000
Features