Set Up Automated Attendant To Answer Outside Calls - NEC Univerge SV8100 VM8000 InMail System Manual

Issue 1.0
S
S 7
ET
ECTION
To enable Automated Attendant to answer outside calls, set up Direct Inward Lines
(DILs) and terminate them to VM8000 InMail.
Automated Attendant enables the following capabilities:
To Set up the Automated Attendant to answer outside calls:
1.
1 - 6
You can optionally use 15-07-01 Programming Function Keys to assign a Voice
Mail programmable key (code 77).
If you don't assign the Message key or a programmable key for Voice Mail access,
an extension user can access his mailbox by the following actions:
Press Speaker key
Ì
Dial VM8000 InMail pilot number
Ì
Dial mailbox number
Ì
U A
P UTOMATED
All calls are answered by Call Routing Mailbox 1 and Dial Action Table 1. This
happens because:
Answer Table 1 Runs Monday-Friday from 8:30AM to 5:00PM, and uses Call
Routing Mailbox 1.
At all other times, the Default Mailbox answers – also using Call Routing Mailbox 1.
Dial Action Table 1 allows outside callers to perform the following actions:
Dial system extensions (if installed).
Dial 0 for an operator (extension 101).
Dial * + Extension to leave a Quick Message in a mailbox.
Dial # + Extension to remotely log on to their mailbox.
Wait on the line to be automatically routed to the operator.
Set up trunks as Direct Inward Lines.
22-02-01 Incoming Call Trunk Setup
Assign Service Type 4 to each trunk you want to be a DIL. Make a separate
entry for each Night Service mode.
By default, trunks are Service Type 0 (Normal).

A A
TTENDANT TO
O
NSWER UTSIDE
VM8000
C
ALLS
Quick Setup