Rop.setup.software; Register The Unit In The Rop Setup Software [Rop List] - Panasonic AK-HRP200G Operating Instructions Manual

ROP.Setup.software

First, register the IP address of the ROP on the [ROP List] tab of the
ROP Setup Software.
Once the IP address has been registered, configure the settings of
devices on the [Configuration] tab, [Camera List] tab, and [UserAuth.]
tab.
Upon starting the ROP Setup Software, the [Configuration] tab is
displayed first.Configuration Click tabs to select them and register IP
addresses and make settings.
<Note>
When making settings from a personal computer using the ROP Setup
Software, please pay attention to the following points.
• Do not start up the ROP Setup Software while the unit is in the setup
mode.
• Do not start up the ROP Setup Software on another personal computer
on the same network.
• After using the setup software to configure connection settings, we
recommend backing up the setting data. Save it to a memory card
while the unit is in setup mode
No. Item
5 Save ROP configuration file to memory
card
Register.the.unit.in.the.ROP.Setup.Software.[ROP.List].
On the [ROP List] tab, register the IP address of the unit in [HRP1] of the
ROP Setup Software.
When connecting multiple ROPs to the network, register one of the units
in [HRP1] and then register the other ROPs (AK-HRP200) connected to
the network. ROPs registered here can be selected from the list box of
the [Camera List] tab. Up to 25 units can be registered.
1
Reference.page
1..
Set.IP.addresses.in.[HRP1]..
page 13
1) On the [HRP1] line under ROP NO, (1) enter the IP address of the
unit to be registered
2) Click the [REGISTER] button (6) to confirm the [HRP1] setting.
2..
Make.settings.for.multiple.units..
Settings can be made by the following two methods.
z Register.IP.addresses.assigned.to.devices.in.the.IP.address. .
column.(2).in.the.same.manner.as.with.[HRP1].
z Click.the.[NETWORK.SEARCH].button.(5).to.acquire. .
information.for.the.HRP200s.in.the.same.segment.
• A list is displayed in [HRP2] to [HRP25].
Click the [REGISTER] button (6) to confirm the [HRP1] setting.
Registered ROPs are displayed in the Master ROP Number (7) list
box.
When.you.want.to.change.ROP.numbers.in.the.list.
Swap HRP200s set as connection destinations between two ROP
numbers.
1) Click
A list of ROP numbers [HRP2] to [HRP25] is displayed.
2) Select the ROP number with which you want to make the swap.
3) Click the [REGISTER] button (6) to confirm the change.
<Note>
The length of time required for setting after you click the
[REGISTER] button (6) is proportional to the number of ROPs
connected. When there are 25 ROPs connected, it takes up to
about 10 minutes.
3..
Confirm.ROP.connection.on.the.network..
Click the [CONNECTION CHECK] button (4) on the ROP No. row
corresponding to the ROP to be checked.
If communication is performed correctly, the green tally display
<TALLY/CALL> of the applicable HRP200 flashes for 3 seconds. If it
does not flash, check the settings and connection.
7 2
5 6
in the SWAP ROP No. column (3).
3 4
35