Panasonic AK-HRP200G Operating Instructions Manual page 38

ROP.Setup.software.
(continued)
<Note>
z Caution when setting camera numbers
Be careful with regards to the following points when configuring the settings in [Camera List] for each HRP200.
• Decide the number of each camera beforehand, and set [Camera List] so that each camera number becomes the same as in the settings of all
ROPs.
C01
AK-HCU200
IP address: 192.168.0.20
Serial connection
CAMERA NO CAMERA TYPE
C01
C02
For example, when connecting each of both a CCU and ROP with a serial connection and IP connection as shown in the figure above, set [C01] to a
serial connection and [CO2] to an IP connection for [Camera List] of HRP1.
For [Camera List] of HRP2, use [SWAP CAMERA] to set [CO1] to an IP connection and [CO2] to a serial connection.
• When you perform a search with [NETWORK SEARCH], all of the cameras and CCUs (C01 and C02) in the same segment will be found, but
change the camera that has already been set with a serial connection to [NoAssign].
38
IP connection
IP connection
AK-HRP200
IP address:
192.168.0.130
IP ADDRESS
CCU Serial
CCU IP 192.168.0.21
C02
AK-HCU200
IP address: 192.168.0.21
IP connection
Switching hub
IP connection
CAMERA NO
C01
C02
Serial connection
AK-HRP200
IP address:
192.168.0.131
CAMERA TYPE IP ADDRESS
CCU IP 192.168.0.20
CCU Serial