Set Up User Authentication [User Auth.] - Panasonic AK-HRP200G Operating Instructions Manual

ROP.Setup.software.
(continued)
Set.up.user.authentication.[User.Auth.]
To control CCUs, remote cameras or camera recorders that have the
user authentication function enabled, you need to set the user name and
password on the unit. Configure this setting on the [User Auth.] tab of
this software.
The user authentication function is only enabled when the unit is
controlling CCUs, remote cameras or camera recorders connected with
IP connection. Also refer to the operating instructions for the various
devices.
1
2
3
4
5
6
7
1..
In.the.selection.list.box.(1),.select.the.ROP.for.which.you.
want.to.make.connection.settings..
• Click in the selection list box (1) to display the IP addresses
of ROP units that can be set. From among these, select the ROP
whose IP address you want to set Any of the units registered on the
[ROP List] tab can be selected.
2..
Click.the.[REFRESH].button.(7)..
• The user name set on the ROP selected in the selection list box (1)
is displayed in the [Old User Name] box (2).
• The ROP factory default user name is [admin].
3..
In.the.[New.User.Name].box.(3),.enter.the.new.user.name.
to.set..
4..
In.the.[Old.Password].box.(4),.enter.the.password.set.on.
the.selected.ROP..
• Entered characters are displayed as [
• The ROP factory default password is [12345].
5..
In.the.[New.Password].box.(5),.enter.the.new.password.
to.set...
• Entered characters are displayed as [
6..
In.the.[Retype.New.Password].box.(6),.enter.the.same.
password.entered.in.step.5..
• Entered characters are displayed as [
7..
Click.the.[SET].button.(8)..
• The user name and password are set on the ROP selected on the
list box (1).
• When cameras with the user authentication function enabled are
controlled, the user name and password that were set here are
used.
<NOTE>.
• Even if you have forgotten the new password you set by performing
the procedure above, you can still configure the settings again by
entering [admin] in the [Old User Name] box and [12345] in the [Old
Password] box and then entering a new user name and password in
the other boxes.
• Default user authentication settings for connected devices are as
follows.
When user authentication is enabled, all connected devices must
have the same [USER NAME] and [PASSWORD].
CCU
Remote camera
Camera recorder
8
].
*
].
*
].
*
User.Name Password
admin 12345
admin 12345
guest p2guest
z User.authentication.for.camera.recorders .
User authentication is always enabled for camera recorders.
In order to use IP connection with camera recorders, set user
authentication as follows. (When the camera recorder has the
default settings)
1..On.the.[User.Auth].tab,.set.the.user.authentication.(User.
Name).and.password.(Password).as.follows.
User Name: guest
Password: p2guest
2..On.the.[Camera.List].tab,.set.the.camera.type.to.be.
connected.(CAMERA.TYPE),.the.IP.address.(IP.ADDRESS).
and.the.camera.port.number.(CAMERA.PORT.No).as.
follows.
CAMERA TYPE: Camcoder IP
IP ADDRESS: 192.168.0.1
CAMERA PORT NO. : 49152
For settings and setting procedures applicable to camera
recorders, please refer to the camera recorder operating
instructions.
39