GE LOGIQ E9 User Manual page 105

Distance measurement
HINTS
–
LOGIQ E9 User Guide
Direction 5454884-100 English Rev. 1
To make a distance measurement:
1. Press Measure once; an active caliper displays.
2. To position the active caliper at the start point, move the
Trackball.
3. To fix the start point, press Set.
The system fixes the first caliper and displays a second
active caliper.
4. To position the second active caliper at the end point, move
the Trackball.
A dotted line connects the measurement points, if preset
accordingly.
5. To complete the measurement, press Set.
The system displays the distance value in the Results
Window.
The following hints can help you to perform distance
measurements:
• Before you complete a measurement:
• To toggle between active calipers, press the top
Trackball key.
• To erase the second caliper and the current data
measured and start the measurement again, press
Clear once.
• After you complete the measurement:
• To rotate through and activate previously fixed calipers,
adjust Cursor Select.
• To erase all data that has been measured to this point,
but not data entered onto worksheets, press Clear.
Measurement and Analysis
2-19