GE LOGIQ E9 User Manual page 98

Performing an Exam
Split Screen
Dual Caliper
Freezing an image
NOTE:
Activating CINE
2-12
To activate a dual split screen, press L or R.To activate a quad
display, press and hold down L.
When you activate Split Screen by pressing L, the single image
is placed on the left side; when you activate Split screen by
pressing R, the single image is placed on the right side.
To switch between active images, press L/R.
To deactivate, press R until the screen changes.
In split screen, you can draw a caliper, area, ellipse, or spline
trace on both the left and right image at the same time.
Whichever side of the screen that you annotate is called the
"Original" graphic. The copy is called the "Shadow" graphic.
To freeze an image,
1. Press Freeze. The Freeze key backlight turns green.
If you are in a mixed mode, both screen formats stop
immediately. Deactivating Freeze restarts both modes and
places a black bar on the trace to indicate the time discontinuity.
To reactivate the image,
1. Press Freeze again.
Deactivating Freeze erases all measurements and calculations
from the display (but not from the worksheet).
Use the Trackball to start CINE after pressing Freeze.
To activate CINE,
1. Press Freeze.
2. Move the Trackball.
LOGIQ E9
Direction 5454884-100 English Rev. 1
–
User Guide