Terminal Operation Using The Headset - NEC DT830 Series User Manual

STEP 4: If transferring party hangs up, that station's
number appears in the center of recipient's
display.
Transferring station
TRANSFER 2000
1:25 PM
Mic
TERMINAL OPERATION USING THE
HEADSET
DT830 DT430/410
The following procedure explains how to operate a ter-
minal using the headset. While using the headset, the
operations equivalent to answering and ending a
phone call are available by pressing the Headset key.
Note: Headset key must be programmed in advance.
For the programming of Headset key, contact the
system administrator.
To Originate a Call
STEP 1: Press the Headset key, and the Headset key
lights red.
STEP 2: Line key lights green and receive dial tone.
STEP 3: Dial a desired telephone number, after the
target party answers the call, you can start a
conversation.
STEP 4: Press Headset key to end the call, and the
Headset key turns off.
DDD 3
MON 22 SEP 2014
>>>
Note: To switch to handset mode, lift the handset and
press Headset key during a conversation
To Answer a Call
STEP 1: Press the Headset key while the ringing tone
is on, and the Headset key lights red.
STEP 2: Press the flashing line key to start a conver-
sation with another line. Depending on the in-
stallation phase, you can answer the call by
pressing
STEP 3: Press Headset key to end the call, and the
Headset key turns off.
Note:
To switch to headset mode, press Headset key
during a conversation.
104
key instead of line key.
Answer