NEC DT830 Series User Manual page 41

Wall
WM-L UNIT
Screws (suppulied)
- When attaching WM-L UNIT to the wall plate:
Attach WM-L UNIT to the posts on the wall
plate as shown in the figure below.
Switch box
Posts
The remainder of the procedure varies between DT430
Series and DT830 Series.
- In the case of DT430 Series: Go to the next
step.
- In the case of DT830 Series: Go to Step 8
after the LAN cable is connected to the tele-
phone.
STEP 4: Attach the modular terminal to the wall as
shown in the following figure. If the modular
Wall
WM-L UNIT
Screws
WM-L
connector is attached directly on the wall or
the wall plate is used instead of modular ter-
minal, skip this step.
Wall
STEP 5: Insert the line cord plug (included with the
telephone set) into the modular connector.
STEP 6: Insert the line cord plug into the LINE connec-
tor on the back of the telephone. Wrap the ex-
cess cord and secure it with a tie wrap.
33
WM-L
Modular Terminal
Modular Terminal
Line Cord