NEC Aspire Series Networking Manual page 124

Programming
10-03 : PCB Setup
11 Networking System Number (NW
mode only)
12 - Not Currently Used -
13 - Not Currently Used -
14 Service Protocol for S-Point
15 Alert Tone When S-Bus Terminal
Calls Busy Extension
This option determines for S-Bus ter-
minals what a user on an S-Bus termi-
nal will hear when a busy extension is
called. If this option is set to "0", the
user will hear an alert tone. If this
option is set to "1", the user will be
disconnected.
17 Ringback Tone to Telco Now Possi-
ble with BRI Trunks
This option can be used to determine
whether or not the system sends ring-
back tone to the telco.
18 Type of Number
Use this option to deÞne the ISDN
numbering plan to allow the calling
party information to be passed to some
telcos. Note that with software
4.08-4.0W, Program 99-01-32 was
used instead.
19 Numbering Plan IdentiÞcation
passed to some telcos. Note that with
software 4.08-4.0W, Program
99-01-33 was used instead.
114 ◆
0-50
0 = Keypad Facility
1 = SpeciÞed Protocol for Aspire System
0 = Alert Tone
1 = Disconnected
0 = Unknown
1 = International number
2 = National number
3 = Network SpeciÞc number
4 = Subscriber number
5 = Abbreviated number
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
Note 1. The start port number of a BRI line is displayed. Two logic ports are automatically
assigned to a BRI line.
Each timer value of Layer3 are set up for every type of Program 81-06 (T-Bus) and Pro-
Note 2.
gram 82-06 (S-Bus).
0 = Disable
1 = Enable
0
0
0
0
0
0
3
1
Networking