NEC Aspire Series Networking Manual page 169

Item
No.
16 Forced Release of Held Call
Use this option to enable/disable forced
release for calls on Hold. If enabled, the
system disconnects a call if it is on Hold
longer than a programmed interval (Pro-
gram 24-01-05). If disabled, forced dis-
connection does not occur. Program
24-01-01 also affects this option.
17 Trunk to Trunk Warning Tone for Long
Conversation Alarm
Use this option to enable or disable the
Warning Tone for Long Conversation fea-
ture for DISA callers.
18 Warning Beep Tone Signaling
19 Privacy Mode Toggle Option
Use this option to enable or disable a
trunk's ability to be switched from private
to non-private mode by pressing the line
key or Privacy Release function key.
20 Block Outgoing Caller ID
Allow (1) or prevent (0) the system from
automatically blocking outgoing Caller ID
information when a user places a call. If
allowed (i.e. block, enabled), the system
automatically inserts the Caller ID block
code *67 (deÞned in 14-01-21) before the
user dialed digits.
21 Caller ID Block Code
Enter the code, up to 8 digits, that should
be used as the Caller ID Block Code. This
code is automatically inserted before
dialed digits if Program 14-01-20 is set to
'1'.
22 Caller ID to Voice Mail
Enable or disable the system's ability to
send the Caller ID digits (Remote Log-On
Protocol) to voice mail.
23 LCR - Not Used in U.S.
24 Trunk-to-Trunk Outgoing Caller ID
Through Mode
Enable or disable the Trunk-to-Trunk Out-
going Caller ID Through Mode. This
option allows Caller ID from the original
outside caller to be displayed when a
trunk is forwarded off premise.
This option can only be used with PRI and
SIP trunks.
Networking
Item
14-01 : Basic Trunk Data Setup
Input Data
0 = disable
1 = enable
0 = disable
1 = enable
0 = disable
1 = enable
0 = disable
1 = enable
0 = Allow
1 = Block
Dial (up to 8 digits)
0 = disable
1 = enable
0 = disable
1 = enable
Programming
Related
Default
Program
0 24-01-05
0
0
0
0
*67
0
0
0
◆ 159