Behavior During Operation; Examples Of Configuration Control; Station Master Hcs4300 - Siemens SIPLUS HCS Series Operating Instructions Manual

Configuring/Programming
8.5 Configuration control
8.5.3.5

Behavior during operation

Response when modules are missing
If modules are entered as not present in the control data record, the automation system
behaves as follows:
● Any modules identified as not present in the control data record do not return any
diagnostics. Its state is always OK. The value status is OK.
● Direct write access to the outputs that are not present or write access to the process
image of the outputs that are not present: Remains without effect; no access error is
signaled.
● Direct read access to the inputs that are not present or read access to the process image
of the inputs that are not present:
Value "0" is supplied; no access error is signaled.
Note
The configuration from the control data record DS196 must match the actual available
configuration of the HCS.
Otherwise the system cannot start up.
8.5.4

Examples of configuration control

8.5.4.1

Station master HCS4300

Station master HCS4300
In the following a station master, comprising CIM4310, PM Temp, three POM4320s, is
configured.
Figure 8-2
100
Station master HCS4300
SIPLUS HCS4300 PROFINET/PROFIBUS DP
Operating Instructions, 10/2019, A5E35452705A/005