Table of Contents
Advertisement
Introduction
1.1 Introduction
Scope of the document
This document is valid for all components of the SIPLUS HCS4300 specified below and
describes the current delivery state.
Note
Applicable for devices up to firmware version 1.x of the CIM:
• A maximum of 6 POMs can be operated.
• Expansion module, PMs and the DP connection are not available
• The following applies for reading data records 152, 200 and 201: The information that is
read is always for the full configuration, i.e. for 54 channels or 6 POMs.
• The data records 160, 190 and 202 are not available.
Applicable for devices up to firmware version 2.1 of the CIM:
• No phase control can be configured for a POM4320.
• Data record 50 is not available.
Applicable for devices up to firmware version 2.3 of the CIM:
• POM4320 Highend cannot be configured.
Applicable for devices as of firmware version 2.3 of the CIM:
• The "Phase control" mode is only available for POM4320 with MLFB -0AA2 as of
HW version 02.
Naming conventions and abbreviations
Instead of product labels, the following abbreviations are also used in this document.
The following product labels and abbreviations are used:
Product label
Central Interface Module
I/O module
Power Output Module
SIPLUS HCS4300
Registered trademarks
SIPLUS ® is a registered trademark of Siemens AG.
10
Abbreviation
CIM
PM
POM
HCS
Operating Instructions, 10/2019, A5E35452705A/005
SIPLUS HCS4300 PROFINET/PROFIBUS DP
Advertisement
Table of Contents
