Siemens SINUMERIK Series Operating Manual page 206

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Machining the workpiece

6.7 Starting machining at a specific point

Block search mode

Without calculation

With program test

Search mode for ShopMill programs

● The search variant for the ShopMill machining step programs can be specified via MD

51024. This applies only to the ShopMill single-channel view.

For additional information, please refer to the following documentation:

SINUMERIK Operate Commissioning Manual

For a quick search in the main program.

Calculations will not be performed during the block search, i.e. the calculation

is skipped up to the target block.

All settings required for execution have to be programmed from the target

block (e.g. feedrate, spindle speed, etc.).

Multi-channel block search with calculation (SERUPRO).

All blocks are calculated during the block search. Absolutely no axis motion

is executed, however, all auxiliary functions are output.

The NC starts the selected program in the program test mode. If the NC

reaches the specified target block in the actual channel, it stops at the begin‐

ning of the target block and deselects program test mode again. After con‐

tinuing the program with NC start (after REPOS motion) the auxiliary func‐

tions of the target block are output.

For single-channel systems, the coordination is supported with events run‐

ning in parallel, e.g. synchronized actions.

The search speed depends on MD settings.

Machine manufacturer

Please observe the information provided by the machine manufacturer.

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0