Siemens SINUMERIK Series Operating Manual page 516

Programming technological functions (cycles)
10.4 Turning - milling/turning machine
Parameter
TC
Retraction
(for ShopMill program)
ZR
(for ShopMill program)
Align tool through beta and gamma angles
β
(for ShopMill program)
γ
(for ShopMill program)
Directly position rotary axes
B1
(for ShopMill program)
C1
(for ShopMill program)
αC
(for ShopMill program)
516
Description
Name of the swivel data set
Note: The selection box only appears if more than one swivel data set has been set
up.
No The axis is not retracted before swiveling
Retraction in the direction of machine axis Z
Retract towards the machine axis Z and then in the direction X, Y
Maximum retraction (up to the software end position) in the tool direction
Incremental retraction (specified retraction distance, up to the software
end position) in the tool direction
When retracting in the tool direction, in the swiveled machine state, several axes
can move (travel).
Retraction path - only for incremental retraction in the tool direction
Align tool with swivel axes
● Input value
The required angle can be freely entered
● β = 0°
● β = 90°
● 0°
● 180°
● The required angle can be freely entered
Directly align tool with swivel axes:
The required angle can be freely entered
The required angle can be freely entered
Rotational position for a pole position
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
Degrees
Degrees
Degrees
Degrees
Degrees
Milling