Siemens SINUMERIK Series Operating Manual page 413

Procedure
Parameters - "Grid" position pattern
Parameter Description
LAB Repeat jump label for position
(only for G code)
PL Machining plane
(only for G code)
Z0 (only for Shop‐ Z coordinate of reference point Z (abs)
Mill)
X0 X coordinate of the reference point X (abs)
This position must be programmed absolutely in the 1st call.
Y0 Y coordinate of the reference point Y (abs)
This position must be programmed absolutely in the 1st call.
α0 Angle of rotation of the line referred to the X axis
Positive angle: Line is rotated counter-clockwise.
Negative angle: Line is rotated clockwise.
αX Shear angle X
αY Shear angle Y
L1 Distance between columns
L2 Distance between rows
N1 Number of columns
N2 Number of rows
Parameters - "Frame" position pattern
Parameter Description
LAB Repeat jump label for position
(only for G code)
PL Machining plane
(only for G code)
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
1. The part program or ShopMill program to be processed has been created
and you are in the editor.
2. Press the "Drilling" softkey.
3. Press the "Positions" softkey.
4. Press the "Grid" softkey.
- OR -
Press the "Frame" softkey.
The "Position grid" or "Position frame" input window opens.
Programming technological functions (cycles)
10.1 Drilling
Unit
mm
mm
mm
Degrees
Degrees
Degrees
mm
mm
Unit
413