Siemens SINUMERIK Series Operating Manual page 337

Parameters
Coolant 1
Coolant 2
Tool-spec. function 1
Tool-spec. function 2
Tool-spec. function 3
Tool-spec. function 4
DT
Programmed stop
Stop
Note
Coolant after a block search
After a block search, the coolant specified for a tool in the tool management is always output
after a block search even if a different coolant is programmed here.
In this case, the desired coolant can be activated with the "Overstore" function.
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Description
Selects coolant (switches coolant 1 on or off)
● with
● without
Selects coolant (switches coolant 2 on or off)
● with
● without
User machine functions on/off
User machine functions on/off
User machine functions on/off
User machine functions on/off
Dwell time in seconds
Time after which machining is continued.
Programmed stop on
Stops machining at the machine if, under Machine in the "Program control"
window, the check box "Programmed stop" was activated.
Stop on
Stops machining at the machine.
Creating a ShopMill program
9.9 Defining machine functions
Unit
s
337