Simulating The Program Block By Block - Siemens SINUMERIK Series Operating Manual

Simulating machining
7.7 Program control during the simulation
7.7.2

Simulating the program block by block

You have the capability of controlling the program execution during the simulation, i.e. to
execute a program, e.g. program block by program block.
Procedure
Switching a single block on and off
288
1. Simulation is started.
2. Press the "Program control" and "Single block" softkeys.
3. Press the "Back" and "Start SBL" softkeys.
The pending program block is simulated and then stops.
4. Press "Start SBL" as many times as you want to simulate a single program
block.
5. Press the "Program control" and the "Single block" softkeys to exist the
single block mode.
Press the <CTRL> and <S> keys simultaneously to enable and disable the
single block mode.
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Milling