Siemens SINUMERIK Series Operating Manual page 589

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Example of the limit in longitudinal external machining

Figure 10-13

Figure 10-14

Feedrate interruption

To prevent the occurrence of excessively long chips during machining, you can program a

feedrate interruption. Parameter DI specifies the distance after which the feedrate interruption

should occur.

The interruption time or retraction distance is defined in machine data.

Residual material machining / naming conventions

G code program

For multi-channel systems, cycles attach a "_C" and a two-digit number of the specific channel

to the names of the programs to be generated, e.g. for channel 1 "_C01".

This is the reason why the name of the main program must not end with "_C" and a two-digit

number. This is monitored by the cycles.

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0

Permitted limit: Limit line XA is outside the contour of the blank

Impermissible limit: Limit line XA is inside the contour of the blank

Machine manufacturer

Please observe the information provided by the machine manufacturer.

Programming technological functions (cycles)

10.5 Contour turning - Milling/turning machine