Monitoring Parameter Identifiers - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring tool management
9.3 Configure the tool lists
Content_identifier
TeethCount
CuttRate
IsoHNoDPH
OrientNo
OrientV1, ...,
OrientV3
EdgeUser_1, ...,
EdgeUser_10,
EdgeAppl_1, ...,
EdgeAppl_10
9.3.3

Monitoring parameter identifiers

For the monitoring parameters, the following identifiers are used in the configuration file:
Content_identifier
SupWarning
SupRemaining
SupDesired
SupWarningTime
SupRemainingTime
SupWarningPieces
SupRemainingPieces
SupDesiredTime
SupDesiredPieces
SupWarningWear
SupRemainingWear
SupDesiredWear
SupExtendedAlarm
SupWarningPiecesIncremental
SupActualPieces
EdgeSupUser_1, ...,
EdgeSupUser_10
EdgeSupAppl_1, ...,
EdgeSupAppl_10
72
Parameter or property
Number of teeth, cutting parameter 24
Cutting rate, cutting parameter 25
ISO H number
Cutting orientation
Cutting orientation vector 1, to
Cutting orientation vector 3
OEM cutting parameter 1, to
OEM cutting parameter 10
Siemens application cutting parameter 1, to
Siemens application cutting parameter 10
Parameter or property
Warning limits, taking the current monitoring type into
consideration.
Actual value, taking the current monitoring type into consideration.
Setpoint, taking the current monitoring type into consideration.
Tool life warning limit
Tool life actual value
Warning limit for count
Actual value for workpiece count
Setpoint for tool life
Setpoint for workpiece count
Prewarning limit for wear
Actual value for wear
Setpoint for wear
PLC tool management - extended alarm
PLC tool management - prewarning limit workpiece count
PLC tool management - actual value workpiece count
OEM cutting monitoring parameter 1, to
OEM cutting monitoring parameter 10
Siemens application cutting monitoring parameter 1, to
Siemens application cutting monitoring parameter 10
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
HMI sl (IM9)