NEC DS1000 Correspondence Course Workbook page 108

DS1000/2000 Correspondence Course
DS2000 System Installation
To CPU
Mod Jack
Latch
faces up
108 DS1000/2000 Workbook
RJ61X Port
Pin Designation
1 4T
2 3T
3 2T
4 1R
5 1T
6 2R
7 3R
8 4R
80000 - 18A
Note
reversal
Installing a Music Source
Power Failure Cut-Through
When system AC power fails, the 4ATRU and 8ATRU PCB automati-
cally cuts through the first 2 trunk circuits to 2 Power Failure Telephone
connections.
To install Power Failure Cut-Through:
1. Locate an available 8-pin jack in a trunk block or station block.
Local codes may prevent you from using a connector on the station
block for optional equipment.
2. For the 8-pin jack chosen, cross-connect the associated wire pair from
the station or trunk block to the cross-connect block.
3. Install a modular jack for each Power Failure Telephone within six feet
of the telephone's location.
4. For each Power Failure Telephone, run one-pair of 24 AWG station cable
from the cross-connect block to the telephone's modular jack.
5. Terminate the station cable WHT/BLU - BLU/WHT leads to the RED
and GRN lugs in the modular jack.
6. Install bridging clips as required.
To 66 Block
WHT-BLU (1T)
Page Out
BLU-WHT (1R)
WHT-ORN (2T)
Music In
ORN-WHT (2R)
WHT-GRN (3T)
Relay Contacts
GRN-WHT (3R)
WHT-BRN (4T)
No Connection
BRN-WHT (4R)
NEC America