NEC DS1000 Correspondence Course Workbook page 79

NEC America
DS1000/2000 Correspondence Course
Install the cabinet, extension blocks and trunk blocks on the MDF.
Removing the Cover
Before wall-mounting, remove the cover
on the Main Equipment Cabinet.
1. Unscrew the two captive screws on the
front of the cabinet cover.
2. Lift up slightly on the front of the cover
— then gently slide the cover back to
remove it.
Mounting the Wall Mount Bracket
Mount the wall mount bracket on the
MDF in a convenient location, about 12"
higher than where you want the bottom of
the cabinet to line up.
Hanging the Cabinet
1. Hang the Main Equipment Cabinet on
the wall mount hanger as shown at
right.
2. Using the remaining two screws that
were packed with the hanger, secure
the cabinet to the plywood back-
board.
Removing the Right Side Panel
Remove the cabinet right side panel to
gain easy access to the ground lugs and
system cabling. The cabinet has two
ground connections: ETH (Earth
Ground) and PBXG (PBX Ground).
1. Remove the two screws that secure
the right side panel to the cabinet.
2. Carefully slide the right side panel
down until it swings clear of the
cabinet.
DS2000 System Installation
4-Slot Cabinet Shown
4-Slot Cabinet Shown
4-Slot Cabinet Shown
DS1000/2000 Workbook 79