NEC DS1000 Correspondence Course Workbook page 84

DS1000/2000 Correspondence Course
DS2000 System Installation
Changing System Configuration/Slot Assignment
84 DS1000/2000 Workbook
If you need to reconfigure your PCBs, use the table below to determine in
which slots you want to install your PCBs. Be sure to assign the extension
numbers.
Note: The 16DSTU in slot 1 is a permanent assignment and cannot be changed.
Slot PCB
1 16DSTU
2
3
4
5
6
7
8
Remove Existing Slot Programming
1. With only the power supply, CPU, and 16DSTU PCB plugged into the
system, power up the system. Connect a display telephone assigned to
the 16DSTU PCB in slot 1 (see page 96 for further information on con-
necting an extension).
2. If the default setup does not meet the site requirements, you may have to
delete some existing slot programming. To clear out existing slot control
programming:
a. Enter
ICM
b. Dial
9902
c. Press
HOLD
2, or
EMPTY SLOT
d. Press
VOL Up
slots 2-8. (Note that slot 1 is permanently assigned as a 16DSTU PCB.
You cannot change this assignment.)
e. Access the slot you want to change and press
REMOVE CARD (Y/N)?
f. Press to return to step 'd' without deleting, or press
N
assignment. You see:
g. Press N. You see
h. Press
HOLD
i. or
VOL Up
program 9902.
Description
16 Digital Station
+ + to enter the programming mode.
#*#* 372000
+ to enter program 9902: Slot Control.
HOLD
again. You see the programmed slot information for slot
if there is no assignment.
or to check the current assignments for
Volume Down
SLOT DATA WILL BE LOST! ABORT (Y/N)?
SLOT CONFIG CHANGED
.
to select another slot, or press
VOL Down
Extensions
300-315
. You see
HOLD
to remove the
Y
.
to exit
CONF
NEC America