NEC DS1000 Correspondence Course Workbook page 86

DS1000/2000 Correspondence Course
DS2000 System Installation
86 DS1000/2000 Workbook
Once you've selected the slot you want to check, press
3.
shows the number of circuits currently displayed and the extension num-
bers assigned to the circuits. For example, if you plugged your first
8ATRU into slot 8, you would see:
SLOT:8 CIRCUIT:1-5
401 402 403 404 405
Press to check any additional circuits on the PCB, press
4. V
to return to step 2, or press
Completing the Reconfiguration
As you plug in your PCBs, make sure to follow the configuration chart you
completed previously.
Using the 0504: View Extension Utility
Use 0504: View Extension to view the extension assignments for each port
(circuit).
Enter the programming mode and dial
1.
0504: View Extension. You see:
Enter the number of the trunk (DS1000: 401-406, DS2000: 401-448) or
2.
extension (DS1000: 300-325, DS2000: 300-395) you want to view +
.
HOLD
DS1000:
You see
STATION nn
DS2000:
You see
SLOT:n CIRCUIT:n
ment Cabinet slot where the extension is located; CIRCUIT is the port
(circuit) on the PCB assigned to the slot.)
Press and return to step 2 above to view another extension, or press
3. HOLD
+
HOLD CONF
twice to exit program 9902.
CONF
EXT NUM?
for your selection (NN is the assigned port).
for your selection. (SLOT is the Main Equip-
to exit.
. The display
V
CONF
to enter program
0504 + HOLD
NEC America
+
HOLD