Panasonic PAW-VP1000LDHW Technical Manual page 91

Wiring system diagram
Power supply
220–240 V~,
50/60 Hz
Ground
WHT
1 1
BLK
2 2
Remote controller
This equipment must be properly earthed.
1. Use shielded wires for inter-unit control wiring (B) and ground the shield on both
sides, otherwise misoperation from noise may occur. Connect wiring as shown in
figure before.
2. Connecting cable between indoor unit and outdoor unit shall be approved poly-
chloroprene sheathed 5 or 1.5 mm² flexible cord. Type designation 60245 IEC57
(H05RN-F, GP85PCP etc.) or heavier cord.
3. Use the standard power supply cables for Europe (such as H05RN-F or H07RN-F
which conform to CENELEC (HAR) rating specifications) or use the cables based
on IEC standard. (60245 IEC57, 60245 IEC66)
WARNING
► Loose wiring may cause the terminal to overheat or result in unit malfunction. A fire
hazard may also occur. Therefore, ensure that all wiring is tightly connected.
► When connecting each power wire to the terminal, follow the instructions on sec.
„How to connect electrical wires and sensors" auf Seite 95
curely with the terminal screw.
PAW-VP•LDHW - Technical Manual – 2019-11
RTC5B
L
L
N
N
B
U1
U2
D
R1
Ground
R2
Single-phase model connections
Outdoor unit (1-phase)
INV unit
C
L
N
U1
U2
Ground
and fasten the wire se-
Electrical Wiring
A Power supply
L
220–240 V~,
N
50/60 Hz
Ground
Shielded wire
Ground
6.4
7
91