How To Connect Temp Sensors Ta, E1, E2, E3 To The Tank System; How To Mount The E1, E2 And E3 Sensors On The Pipes - Panasonic PAW-VP1000LDHW Technical Manual
Air-to-water heat pump systems, domestic hot water system for r410a and r32 use
Hide thumbs
Also See for PAW-VP1000LDHW:
- Installation manual (88 pages) ,
- Technical manual (120 pages)
Table of Contents
Advertisement
Electrical Wiring
7.4.2 How to connect temp sensors TA, E1, E2, E3 to the tank system
i
!
7
!
7.4.3 How to mount the E1, E2 and E3 sensors on the pipes
96
Terminal PAW-VP-RTC5B-PACi
Note
Remember that the E2 sensor is required.
Important
When using RTC5B PACi together with DHW tank remove jumper for E2-E2 and connect the sensor E2.
Terminal PAW-VP-RTC5B-ECOi
Important
When using RTC5B ECO together with ECOi MF3 DHW tank and air to air indoor unit remem-
ber to install adapter CZ-CAPE2 for solenoid valve kit.
Maximum contact
Most sensitive point of the thermistor
Cover the thermistor and the pipe with
aluminum tape, then the aluminum
tape with thermal insulation.
PAW-VP•LDHW - Technical Manual – 2019-11
Hide quick links:
Advertisement
Table of Contents
