Mounting The Hopper To The Tow Chassis; Connecting The Intermediate Wire Harness - Toro ProPass 200 Operator's Manual

Figure 12
Hopper extension kit installed
4
Mounting the Hopper to the
Tow Chassis
Parts needed for this procedure:
6 Bolt
6 Flange nut
Procedure
Note: If mounting the machine hopper to other equipment,
refer to the installation instructions for the equipment.
1. Attach a lifting device to the lifting bracket bolted
inside the hopper assembly
Figure 13
1. Lifting bracket
(Figure 13).
WARNING
Do not attempt to lift the bed and hopper
with the Tow-Behind Chassis, ProGator,
Workman, or TDC Chassis connected. The
lifting bracket is not capable of lifting the
entire machine.
2. Using a lifting mechanism, position the hopper over
the tow chassis.
3. Line up the 6 mounting holes (3 per side) and install
the 5/16 x 1 inch bolts and flange nuts.
1. Mounting locations (3 each side)
4. Remove the lifting bracket from the hopper sides and
install the bolts to the hopper sides.
Note: Retain the lifting bracket for future use; do
not discard it.
5
Connecting the Intermediate
Wire Harness
Parts needed for this procedure:
1 Intermediate wire harness
Procedure
Plug the intermediate wire harness into the power harness
connector on the machine
13
Figure 14
(Figure 15 or Figure 16).