Toro ProPass 200 Operator's Manual page 21

Wireless Control (Model 44751): Set according to the
percentage indicated in the colored section of the decal and
on the chart on the back of the wireless controller
Adjusting the Slide
The slide adjustment positions the sand as it falls onto the
discs. The decal not only indicates the color coded start
position for each application, it illustrates the adjustment
required to fine tune your spread; refer to
Adjustments (page 21).
Slide Decal Symbol
Figure 36
(Figure
Figure 37
Fine Tuning the
Figure 38
Note: The colors on the decal shown in
correspond to the colors in the main operation decal
28).
Adjusting the Floor Speed
37).
The floor speed for every setting is usually 100%; this was
developed and tested in order to have one less factor to adjust
in the Color-Coded Operating System. Typically, you should
use the tailgate to reduce material volume, not the floor
speed; however, if the minimum tailgate height is insufficient
to reduce material flow, then decrease the floor speed.
Floor Speed Decal Symbol
Fine Tuning the Adjustments
The color-coded operation system was developed to take the
guess work out of getting a perfect spread. However, with so
many variables such as sand weight, granule size, moisture
content, etc, your spread may still be uneven.
To correct this, the base setting adjustment has an
illustration indicating the correct re-positioning of the base
(Figure 41).
21
Figure 39
Figure 39
Figure 40
(Figure