Storage - Toro ProPass 200 Operator's Manual

Figure 57
1. Clean Out Decal
Figure 58
1. Front Clean Out
11. Inspect the hopper, bottom guard, conveyor belt, bed,
and rollers to ensure that all trapped material is gone.
12. Lower the machine back into the normal operating
position
13. Re-install the belt cleaning scraper assembly. Push
the scraper mount bar onto the belt. Ensure that the
scraper is as vertical as possible, but still in contact with
the belt.

Storage

Before storing the machine for the season:
1. Thoroughly clean the machine. Remove parts if
necessary.
2. Remove the hand held.
3. Make sure the emergency stop button is pushed.
4. Check all fasteners and tighten, if necessary.
5. Grease all fittings and pivot points. Wipe off any excess
lubricant.
6. Lightly sand any painted areas that are scratched,
chipped, or rusted, and apply touch-up paint.
7. Store the machine indoors, if possible.
37