Toro ProPass 200 Operator's Manual page 29

enforced. The timer resets to ten seconds if any button is
pressed while the remote is in the set-only.
1. Press the O
PTION
The preview value and FLRS displays.
2. Adjust the speed setting using the I
S button or the D
PEED
button.
3. Press the O
PTION
4. Press the O
PTION
value.
The display shows OPTION STORE. The set value
will be used whenever the option is started in the future
until you change the setting again.
Setting and Operating the Floor and
Option Together
Upon initially pressing the A
the option is not running), the remote display shows the floor
and option stored settings and an S is displayed after FLR and
OPT (i.e. FLRS and OPTS), indicating that the remote is in
a set-only mode. In this set-only mode, you can adjust either
setting up or down, but the floor and option do not activate,
remaining off. This allows you to set the desired speeds or
use the stored settings without causing unwanted movement.
After setting the speeds, press the A
activate the floor and option at the chosen setting (if the
hydraulics are engaged, the floor and option will start). Press
A S a third time to store the current value in memory.
LL TART
Note: Changes to the settings while the floor and option are
running are immediately effective, but they are temporary
unless you store the new setting by pressing A
again after changing the setting. For instance, you make
an adjustment while the display shows FLRS and OPTS,
press A S starting the floor and option at the adjusted
LL TART
setting, and then turn the remote off without pressing A
S button.
TART
NCREASE
O S
ECREASE PTION
or
S button to start the option.
TART
S button to store the option
TART
S button
LL TART
S button to
LL TART
S
LL
S again, storing the change. The next time you use the
TART
remote, the settings will revert to the previously stored values.
Note: A 10 second timer starts when you press A
and set-only mode displays. If you do not press a button
during the 10 second interval, the display reverts to FLR and
OPT and the previous state/value displays and is enforced.
The timer resets to ten seconds if any button is pressed while
the remote is in the set-only.
1. Press the A
O
PTION
PEED
The preview values and FLRS and OPTS display.
2. Adjust the speed settings as follows:
•
•
3. Press the A
option.
(when
4. Press the A
The display shows ALL STORE. The set value will be
used whenever the option is started in the future until
you change the setting again.
Note: Both the floor and option must be running to
store the settings using the A
one or neither are running, pressing the A
button will either start them both or start the one that
was not running. Nothing is stored and the commands
TART
previewed are the previously stored floor and the
option settings.
It is important to realize that the stored command for
the floor and option are used twice, once in the event
LL
29
S button.
LL TART
Adjust the floor speed setting using the using the
I F S
NCREASE LOOR PEED
F S button.
LOOR PEED
or
Adjust the option speed setting using the using
the I O S
NCREASE PTION
D O S
ECREASE PTION PEED
or
S button to run the floor and
LL TART
S button to store the values.
LL TART
S
LL TART
button or the D
ECREASE
button or the
PEED
button.
S button. If only
LL TART
S
LL TART